ELECTRICAL INSPECTIONS CHECKLIST-FEEDERS
1.1. Verify that feeder conductors, including any required neutral conductors, are adequate for the load.
1.2. Check overcurrent device and feeder conductor sizing for continuous and noncontiguous loads.
1.3. Check wiring methods for suitability.
1.4. Check feeders with disconnecting means rated at 1000 amperes or greater for ground-fault protection for equipment if required.
1.5. Verify that disconnects are provided at separate structures for feeders running between structures.
1.6. Verify that disconnects at separate structures are properly rated, located, grouped, and identified.
1.7. Verify that any outside feeders use appropriate wiring methods and are properly supported and arranged to drain.
1.8. Check any outside feeders for adequate supports, clearances, and mechanical protection.
1.9. Verify that feeders supplied from transformers or from other feeders are properly protected by overcurrent devices.
1.10. Check panel boards supplying or supplied by feeders for overcurrent protection, grounding, and proper enclosures.
1.11. Verify that an identification scheme for ungrounded feeder conductors has been established and made readily available or posted where the premises wiring system has feeders that are supplied by more than one nominal voltage system.
0 Comments