METHOD OF STATEMENT FOR ELECTRICAL WIRING FOR LIGHTING & POWER POINTS -

Introduction And Scope

This method of
statement specifies the detailed requirements and procedures for the MEP
installation (Electrical Wiring For Lighting & Power Points) of the
above-mentioned project.

Methodology-for Electrical Wiring For Lighting & Power Points:

Ensure all the
related documents like currently approved shop drawings and load schedules are
available with the installation team.
Transfer the
required number of wires from stores to the workplace.
Before pulling
wires, check and ensure there are no sharp edges or burrs to prevent damage
while pulling wires.
Identify the
correct size and color. (Following the assigned/specified color coding) of
wire, cut to the required length appropriately.
Do not bunch
two circuits together, if done so, for easy installation. shall be removed
after installation.
Pull the wires
through conduits with the help of pull wires.
Ensure no
joints are made in any circuit.
Leave a
minimum of 250 millimeters in length or more according to the requirement which
should be enough to connect to the desired terminals.
Cover Conduit
junction boxes with appropriate covers.